Sale!

RC Lander 90mm 1000kv 8-10S Metal 12 Blade Dynamic Power EDF

$229.99 $199.99

Item #: RCL-LEDFADPS12B90-1A10/8S
Manufacturer: RC Lander
Manufacturer’s Product Number: RCL-LEDFADPS12B90-1A10/8S
Condition: New

Out of stock

SKU: RCL-LEDFADPS12B90-1A10/8S Categories: , , , , Tags: ,

Description

The RC Lander Dynamic Power Series 8-10S 12 Metal Blade EDF offers great durability with a full metal fan unit that offers good performance.

All RC Lander fans and motors are test run at the factory to ensure that they are in proper operating manner before being shipped out. The fans are put through a series of tests to ensure that they are operating as intended. Be sure to reference the instruction manual for proper motor and esc program settings.

FEATURES:

A lot of EDF units are made of plastic material which during operation creates high temperature. This results in loss of power and the possibility of damage to the motor, battery or speed control. Heat sinks help, but this only offers average improvement. RC Lander Technology uses special metals to improve dissipation of heat in their EDF units. The shroud, spinner and tail pipe are made with a special aluminum alloy that is efficient at heat dissipation. Because of this, the whole shroud acts as a heat sink, removing heat from the motor. The motor and fan unit comes assembled and balanced from the factory. A thermal grease compound is used between the motor and shroud to further help dissipate heat. This is the same compound that is used in computer processors and heat sinks. This design creates a more efficiently running motor and will provide peak performance while extending the lifespan of the motor.

BUILDERS NOTE: REFER TO THE “ELECTRIC SETUP GUIDE” ON THE HOME PAGE TO HELP DETERMINE THE PROPER SET UP FOR FAN, ESC, MOTOR AND BATTERY.

SPECIFICATIONS:

  • Material: Aluminum Alloy
  • Weight: 1.47lb/ 670g
  • Rotor: 90mm, 12 bladed aluminum
  • Outer Diameter: 94mm
  • Motor: 4 Pole In runner

8S Li-Po Set Up:

  • Max RPM: 45,000 rpm
  • Application: 3,500 watts (Max)
  • Application: 3,200 watts (Continuous)
  • Kv Rating: 1000
  • Battery: 8s/ 29.6V Lipo w/ 40C or higher
  • Static Thrust: Up to 4.6kg/ 10.1 lb.
  • Start: Soft
  • Timing: High
  • Amp Rating: 110 amp esc or higher

10S Li-Po Set Up:

  • Max RPM: 48,000 rpm
  • Application: 5,000 watts (Max)
  • Application: 4,800 watts (Continuous)
  • Kv Rating: 1000
  • Battery: 10s/ 37V Lipo w/ 40C or higher
  • Static Thrust: Up to 5.4kg/ 11.9 lb.
  • Start: Soft
  • Timing: High
  • Amp Rating: 130 amp esc or higher

WARNING: Operating the motor outside of the specifications listed above can either damage the motor, battery or esc. It is important that these components are set up properly. Failure to do so can void the warranty. It is strongly encouraged to use a Watt Meter to test the watt and amp performance when setting up a new system. If the output is above the factory recommended specs, then it needs to be adjusted by the esc. The timing and throttle settings on the esc can help to set the appropriate levels.

Picture notice: The kv of the motor is 1000kv. RC Lander does not make a 1700kv edf unit. That is an error on RC Lander’s part to have that stated in the picture.

CA Residents: WARNING: Cancer and Reproductive Harm – www.P65Warnings.ca.gov

Additional information

Weight 1.8 lbs
Dimensions 9 × 7 × 5 in

You may also like…