RC Lander 90mm 1400kv 8S 11 Blade Dynamic Power EDF
Item #: RCL-LEDPS/MDS11B90-1AO14
Manufacturer: RC Lander
Manufacturer’s Product Number: RCL-LEDPS/MDS11B90-1AO14
The RC Lander Dynamic Power Series 8S 11 Blade EDF offers great durability with a metal fan unit that offers good performance. This series features an out runner motor with no tail cone to keep the weight down helping give more efficiency to the edf unit.
All RC Lander fans and motors are test run at the factory to ensure that they are in proper operating manner before being shipped out. The fans are put through a series of tests to ensure that they are operating as intended. Be sure to reference the instruction manual for proper motor and esc program settings.
A lot of EDF units are made of plastic material which during operation creates high temperature. This results in loss of power and the possibility of damage to the motor, battery or speed control. Heat sinks help, but this only offers average improvement. RC Lander Technology uses special metals to improve dissipation of heat in their EDF units. The shroud, spinner and tail pipe are made with a special aluminum alloy that is efficient at heat dissipation. Because of this, the whole shroud acts as a heat sink, removing heat from the motor. The motor and fan unit comes assembled and balanced from the factory. A thermal grease compound is used between the motor and shroud to further help dissipate heat. This is the same compound that is used in computer processors and heat sinks. This design creates a more efficiently running motor and will provide peak performance while extending the lifespan of the motor.
- Material: Aluminum Alloy
- Weight: 17.5 oz.
- Rotor: 90 mm dia., 11-bladed
- Outer Diameter: 94mm
8S Li-Po Set Up:
- Max RPM: 41,4400 rpm
- Application: 3,000 watts (Max)
- Application: 2,871 watts (Continuous)
- Kv Rating: 1400
- Battery: 8s 29.6V
- Thrust: Up to 3.6kg/ 7.93 lb.(Estimated)
- Start: Soft
- Timing: High
- Amp Rating: 100 amp esc or higher
WARNING: Operating the motor outside of the specifications listed above can either damage the motor, battery or esc. It is important that these components are set up properly. Failure to do so can void the warranty. It is strongly encouraged to use a Watt Meter to test the watt and amp performance when setting up a new system. If the output is above the factory recommended specs, then it needs to be adjusted by the esc. The timing and throttle settings on the esc can help to set the appropriate levels.
CA Residents: WARNING: Cancer and Reproductive Harm – www.P65Warnings.ca.gov
|Dimensions||9 × 6 × 4.5 in|