JP Hobby ER-005-200 Multifunction Controller

Description

This control module controls them all.  This JP Hobby Multifunction Control box controls the entire line of JP Hobby retracts from the ER-005 to the ER-200.  It also has three ports for gear doors and operates in both version A and B gear door operations.

Note: Version B closes the doors when the gear is down, while Version A keeps the doors open.

The main difference between the new Combined Retract Controller and the Integrated Retract Controller is that the Combined Retract Controller features three gear door channels, allows the setting of both V1 and V2 versions, and offers the ability to change the direction of the gear door servo.

Additionally, it supports all versions of the ER-005, ER-010, ER-120, ER-150, and ER-200 retract systems, automatically identifying the specific requirements of the landing gear.

• The functions of the JP Hobby module are multiple:
• Automatic detection of the supply voltage
• Adjusting the supply voltage of the servos actuating the gear doors
• Adjusting the direction of rotation of the servos actuating the gear doors
• Mode selection:
  • – 1: Opened gear doors when the landing gear is out.
  • – 2: Closed gear doors when the landing gear is out.

This controller can be used for either monocycle (1 channel), bicycles (2 channels), or tricycles (3 channels) gear systems from JP Hooby.

JP E-Brake Features

• Compatibility: 40-85mm JP Hobby E-Brake sets.
• Signal input: Connect the module to your receiver on a 2 or 3-position switch channel or, for variable braking force, to a slider or rotary (variable) knob on your TX. Some will set up brakes as a mix, with the “down elevator” to save a channel.
• The braking force is controlled by the servo travel/endpoints you set in your TX.

Specifications

• Dimensions: 52x37x14mm
• Entraxe: 64mm
• Voltage range: 7.4-8.4V
• Weight: 34.7g
  

  Gear Door Controller Setup Instructions

  This controller supports three gear door channels, each of which can be configured independently. You can adjust V1/V2 positions and servo directions (positive or negative) for each gear door.

  Function 1: V1/V2 Position Setup

  (V1: landing gears doors stay open – V2 : closed)

  To enter the position setup mode:
  1. Press and hold the Mode key for 5 seconds.
  2. The red light indicates the controller is in V1 setup mode.
  3. Press the Mode key again to switch to V2 mode, indicated by a blue light.

  If the Mode key is not pressed within a few seconds, the controller will automatically move to the next channel.
  Once all three channels have been configured, the system will automatically exit the setup mode.

  Function 2: Servo Direction Setup

  To configure the servo direction (positive or negative):
  1. Press and hold the Mode key for 10 seconds to enter servo direction setup mode.
  2. A red light indicates the positive direction, and a blue light indicates the negative direction.
  (Note: In some models, this color assignment may be reversed.)

  If the Mode key is not pressed, the system will automatically proceed to the next channel.
  After all three channels have been set, the system will exit the setup mode automatically.

Insurance Note:  Fan Jets USA recommends the purchase of shipping insurance. If insurance is not purchased and the package is lost or damaged, the most that can be claimed with the USPS and awarded to the purchaser (shipment recipient) is $50.00.  Fan Jets USA is not responsible for reimbursing the purchaser for the difference in an order of any amount.  Shipping charges are not included in an insurance claim per USPS guidelines.

CA Residents: WARNING: Cancer and Reproductive Harm – www.P65Warnings.ca.gov